

Hello, welcome to visit the official website!Tel:86-769-87281870
Usage:YB-1200 auto V-CUT machine,applicable to the process of PCB alluminum substrate.
It has marble as workbench,which is stable、higher cost-efficiency,and have recognitions of vast customers.
Introduction of specification:
Max process size: 1250mmⅹ650mm
Min process size: 105mmⅹ105mm
Process thickness 0.4mm~3.2mm
Process position it could reach 7.0mm over from the origin to the first cut.
Process space set up within the parameter
it has correction function of full close circle.
Times of cutter jump set up within the parameters
Process precision residual thickness ±0.05mm
Parallel ±0.05mm
Space ±0.05mm
Process speed 0-40m/min
Machine size 2030(W)ⅹ2350(L)ⅹ1665(H )
Machine weight 1500kg
System introduction for electrical control
The up and down cutters use Japanese Mitsubishi servo-motors which has precision of 3µ
The max rotation speed is 3500rpm and the max output power is 400W
The shaft for pushing the board uses Japanese Mitsubishi servo-motors which has precision of 3µ.
The max rotation speed is 3500rpm,the max output power is 700W.
The cutter shaft uses Japanese Mitsubishi servo-motors which has precision of 3µ
The max rotation speed is 3500rpm and the max output power is 1500W.
The up and down sand wheels use Japanese Fuji servo-motors which has the precision of 5µ.
The max rotation speed is 8000rpm and the max power output is 400W.
PLC Module controller use six shafts motion control.
It has very high stability.
Software introduction
System data and PC comprehensive management
Process data transmission to be done within 10 seconds.
Chinese operation system is simple and easy to operate.
The management of process data file could reach 10 thousand lots.
It have the function of data searching and deleting.
The whole procedure testing instrument without board , introduction of action procedure
The machine applies pin bushing action procedure methods from west Germany.
The human-engineering let the operation procedure much more fluent.
Practical function of board production
It has the height matching the human-engineering,letting the operation much easier and more simple.
The mainbody of the machine has the operation height matching the human-engineering,letting the operation much easier.
The main body of the machine has stress relieved,rigidity strengthened, so it is much more stable.
The whole procedure has very high precision, great productivity and high efficiency.
Clamping jaw function introduction
This machine applies 11 independent cylinder clamp jaws
It could adjust the amount of the cylinder flow seperately.
2.50~3.20mm The open nail is grinded finely, the specification is 2.50~3.20mm
It could be used as pin bushing or side holding.
Auto board relief function.